Mono-Mono Serial (Mono-Mono) |551
d [E]B1 Cutoff [Hz] 2 0 …1. 0 0 k Sets the center frequency of Band 1
Q 0.5…10.0 Sets the bandwidth of Band 1
Gain [dB] –18…+18 Sets the gain of Band 1
e [E]B2 Cutoff [Hz] 50…5.00k Sets the center frequency of Band 2
Q 0.5…10.0 Sets the bandwidth of Band 2
Gain [dB] –18…+18 Sets the gain of Band 2
f [E]B3 Cutoff [Hz] 300…10.00k Sets the center frequency of Band 3
Q 0.5…10.0 Sets the bandwidth of Band 3
Gain [dB] –18…+18 Sets the gain of Band 3
g [E]B4 Cutoff [Hz] 500…20.00k Sets the center frequency of Band 4
Q 0.5…10.0 Sets the bandwidth of Band 4
Gain [dB] –18…+18 Sets the gain of Band 4
h Routing
Comp › P4EQ,
P4EQ › Comp
Switches the order of the compressor
and parametric EQ
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
87: Comp - Cho/Flng (Compressor - Chorus/Flanger)
This effect combines a mono compressor and a chorus/flanger. You can
change the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Compressor
Chorus/Flanger
Chorus/Flanger
Feedback
LFO: Tri / Sine
Cho/Flng FX Amt
Normal
Wet Invert
Output Mode
–
+
LEQ HEQ
EQ Trim
Comp
Output Level
Envelope - Control
To Next Page
Loading...
Need help?
General
