552| Effects for the MIDI Sounds
COMPRESSOR
a [C]
Sensitivity
1…10 0 Sets the sensitivity
b [C]Attack 1…10 0 Sets the attack level
Output Level 0…10 0 Sets the compressor output level
c [C]EQ Trim 0…10 0 Sets the EQ input level
d [C]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
CHORUS/FLANGER
e [F]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
f [F]Delay Time [msec] 0.0…1350.0 Sets the delay time
Depth 0…10 0 Sets the depth of LFO modulation
Feedback –100…+100 Sets the feedback amount
g [F]Cho/Flng Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the effect balance of the
chorus/anger
,
Src Off…Tempo Selects the Wet/Dry modulation
source for the chorus/anger
Amt –100…+100 Sets the Wet/Dry modulation
amount for the chorus/anger
h [F]Output Mode Normal,
Wet Invert
Selects the output mode for the
chorus/anger
i Routing
Comp ›
Flanger,
Flanger › Comp
Switches the order of the com-
pressor and chorus/anger
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
h: [F]Output Mode
i: Routing
When Wet Invert is selected, the right channel phase of the chorus/flanger
effect sound is inverted. This creates pseudo-stereo effects and adds spread.
To Next Page
Loading...
Need help?
General
