Modulation and Pitch Shift (Mod./P.Shift) |479
43: Scratch
This effect is applied by recording the input signal and moving the modula-
tion source. It simulates the sound of scratches you can make using a turn-
table.
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Scratch
Direct
Mix
D
-mod
Rec Control
Scratch
a Scratch Source Of f…Tempo Selects the modulation source for simulation
control
b Response 0 …10 0 Sets the speed of the response to the
Scratch Src
c Envelope Select D-mod, Input Selects whether the start and end of record-
ing is controlled via the modulation source
or the input signal level
Src Off…Tempo Selects the modulation source that controls
recording when Envelope Select is set to
D-mod
d Threshold 0…10 0 Sets the recording start level when Envelope
Select is set to Input
e Response 0…10 0 Sets the speed of the response to the end
of recording
f Direct Mix Always On,
Always Off,
Cross Fade
Selects how a dry sound is mixed
g Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
Need help?
General
