430| Effects for the MIDI Sounds
a: OSC Mode
b: Note Interval
b: Note Fine
The “OSC Mode” parameter selects the oscillator operation mode. When
Note (Key Follow) is selected, the oscillator’s frequency is determined based
on the note number, allowing you to use it as an octaver. The “Note Interval”
parameter sets the pitch offset from the original note number by semitone
steps. The “Note Fine” parameter allows you to fine-tune in steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to which very low
harmonics are added. Adjust this parameter if you do not want to add lower
harmonics to the higher range.
15: Talking Modulator
This effect adds an unusual character, like a human voice, to the input signal.
Modulating the tone via dynamic modulation, you can create an interesting
effect that sounds as if the guitar or synthesizer is talking.
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Left
Right
FX Amt
FX Amt
+
D
-mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A - I - U - E - O
Talking Modulator
LFO
D-mod
LFO
Sweep Mode
a Sweep Mode D-mod, LFO Switches between modulation source
control and LFO control
b Manual Voice Control Bottom,
1…49, Center,
51…99, Top
Voice pattern control
Src Of f…Tempo Selects the modulation source that con-
trols the voice pattern
c Voice Top A, I, U, E, O Selects a vowel sound at the top end of
control
d Voice Center A, I, U, E, O Selects a vowel sound in the center of
control
To Next Page
Loading...
Need help?
General
