EQ and Filters (EQ/Filter) |431
e Voice Bottom A, I, U, E, O Selects a vowel sound at the bottom
end of control
f Formant Shift –100…+100 Sets the frequency to which the effect
is applied
Resonance 0…10 0 Sets the Level of resonance of the voice
pattern
g LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
Src Of f…Tempo Selects a modulation source for LFO
speed
Amt –20.00…
+20.00
Sets the modulation amount of LFO
speed
h MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note
…
Selects the type of notes that specify
the LFO speed
Times x1…x32 Sets the number of notes that specify
the LFO speed
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
c: Voice Top
d: Voice Center
e: Voice Bottom
These parameters assign vowels to the top, center, and bottom position of
the controller.
E.g.: When “Voice Top”=A, “Voice Center”=I, and
“Voice Bottom”=U:
If “Sweep Mode”is set to D-mod and Ribbon is selected as the modulation
source, moving your finger from the right to left of the ribbon controller will
change the sound from “a” to “i,” then “u.”
To Next Page
Loading...
