20| Setting up the accessories
Connecting the audio outputs
Connecting the headphones
Connect a pair of headphones to the PHONES/AUDIO OUT connector. You
can use headphones with an impedance of 16-200 Ohms (50 Ohms sug-
gested). When connecting the headphones, the speakers are automatically
deactivated.
Adjust the output level with the VOLUME knob.
In case the connector was set to work as a Line Out, you can choose the
Headphone option by using the Phones/Audio Out > Level parameter in the
Global > Audio & EQ > MP3/Speakers page (see below).
Connecting the audio outputs
Use the PHONES/AUDIO OUT connector to send the audio output to a mixer,
a set of powered monitors, or an audio amplification system. Use a stereo
jack to send the final stereo mix to an external device.
When using a home audio amplifier, connect the other end of the cable to the
CD, LINE IN or TAPE/AUX input of your audio system. Don’t use the PHONO
inputs of your audio system!
Adjust the output level with the VOLUME knob.
In case the connector is set to work as a Phone Out (it is by default), you
can choose the Line Out option by using the Level parameter in the Global >
Audio & EQ > MP3/Speakers page.
To Next Page
Loading...
Need help?
General
