Mono-Mono Serial (Mono-Mono) |567
f [D]Tap2 Time [msec] 0.0…1360.0 Sets the Tap2 delay time
Feedback (Tap2) –100…+100 Sets the Tap2 feedback amount
g [D]High Damp [%] 0…10 0 Sets the damping amount in the high
range
h [D]Mt.Delay Wet/Dry Dry,
1:99…99:1,
Wet
Sets the multitap delay effect bal-
ance
Src Of f…Tempo Selects the Wet/Dry modulation
source for the multitap delay
Amt –100…+100 Sets the Wet/Dry modulation amount
for the multitap delay
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Of f…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
99: OD/HG - Amp Sim (Overdrive/Hi.Gain - Amp Simulation)
This effect combines a mono overdrive/high-gain distortion and an amp sim-
ulation. You can change the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Amp Simulation
Amp Simulation Filter
Overdrive / Hi-Gain
3 Band PEQ
Output Level
Mode: Overdrive / Hi-Gain
Drive
Driver
To Next Page
Loading...
Need help?
General
