496| Effects for the MIDI Sounds
If Feedback Position is set to Post, the feedback signal will not pass through
the pitch shifter again. Even if you specify a higher value for the Feedback
parameter, the pitch-shifted sound will be repeated at the same pitch.
52: Pitch Shifter BPM
This pitch shifter enables you to set the delay time to match the song tempo.
BPM
BPM
Base Note x Times
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Pitch Shifter
Feedback Position
Pre
Post
Tempo
a Mode Slow,
Medium,
Fast
Switches Pitch Shifter mode
b Pitch Shift [1/2tone] –24…+24 Sets the pitch shift amount in steps of a
semitone
Src Of f…Tempo Selects the modulation source of pitch
shift amount
Amt –24…+24 Sets the modulation amount of pitch shift
amount
c Fine [cents] –100…+100 Sets the pitch shift amount in steps of one
cent
Amt –100…+100 Sets the modulation amount of pitch shift
amount
d BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individ-
ual effect
Time Over? ---, OVER! Displays an error message when the de-
lay time exceeds the upper limit
e Delay Base Note
…
Selects the type of notes to specify the
delay time
Times x1…x32 Sets the number of notes to specify the
delay time
f Feedback Position Pre, Post Switches the feedback
connection