Modulation and Pitch Shift (Mod./P.Shift) |497
g Feedback –100…+100 Sets the feedback amount
High Damp [%] 0…10 0 Sets the damping amount in the high
range
h Input Level Dmod [%] –100…+100 Sets the modulation amount of the input
level
Src Of f…Tempo Selects the modulation source for the in-
put level
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
d: BPM
e: Delay Base Note
e: Times
The delay time is the duration of “Times” number of “Delay Base Note” note
values at the “BPM” tempo (or if “BPM” is set to MIDI, the tempo determined
by MIDI Clock).
d: Time Over?
You can set the delay time up to 5,290msec. If the delay time exceeds this
limit, the error message “OVER!” appears on the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.
To Next Page
Loading...
