Mono-Mono Serial (Mono-Mono) |581
109: Reverb - Gate
This effect combines a mono reverb and a gate.
Left
Right
FX Amt
FX Amt
Reverb
Balance
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
LEQ
HEQ
EQ Trim
Reverb
Pre Delay
Envelope - Control
D-mod
Input
Envelope Select
Gate
Input Reverb Mix
Reverb
Gate
Gate+Dmpr
REVERB
a [R]Reverb Time [sec] 0.1…10.0 Sets the reverberation time
High Damp [%] 0…10 0 Sets the damping amount in the high
range
b [R]Pre Delay [msec] 0…200 Sets the delay time of the reverb sound
and gate control signal
c [R]EQ Trim 0…10 0 Sets the EQ input level
Reverb Balance 0…10 0 Sets the reverb effect balance
d [R]PreLEQ Fc Low,
Mid-Low
Selects the cutoff frequency (low or
mid-low) of the low-range equalizer
Pre HEQ Fc High,
Mid-High
Selects the cutoff frequency (high or
mid-high) of the high-range equalizer
e [R]PreLEQ Gain [dB] –15.0…+15.0 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15.0…+15.0 Sets the gain of High EQ
GATE
f [G]Envelope Select D-mod, Input Switches between modulation source
control and input signal control
Src Off…Tempo Selects the modulation source that
controls the gate when Envelope
Select is set to D-mod
g [G]Input Reverb Mix 0 …10 0 Sets the balance between the dry and
reverb sounds of the gate control sig-
nal
Threshold 0…10 0 Sets the gate threshold level
To Next Page
Loading...
Need help?
General
