582| Effects for the MIDI Sounds
h [G]Polarity +, – Switches between non-invert and in-
vert of the gate on/off state
i [G]Attack 1…10 0 Sets the attack time
Release 1…10 0 Sets the release time
j Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry sig-
nal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
f: [G]Envelope Select
f: Src
g: [G]Input Reverb Mix
g: Threshold
The “[G]Envelope Select” parameter enables you to select whether turning
the gate on and off is triggered by the input signal level or controlled directly
by the modulation source. You can select from Off to Tempo for the Src pa-
rameter to specify the modulation source.
When “[G]Envelope Select” is set to Input, the gate is controlled by the level
of signals that are the combination of the dry sound and the reverb sound.
When the signal level exceeds the threshold, the gate opens and the reverb
sound is output.
Normally, set “[G]Input Reverb Mix” to Dry (the gate is controlled only by the
dry sound). If you wish to extend the gate time, set the “[G]Input Reverb Mix”
value higher and adjust the “Threshold” value.
To Next Page
Loading...
