558| Effects for the MIDI Sounds
91: Limiter - Cho/Flng (Limiter - Chorus/Flanger)
This effect combines a mono limiter and a chorus/flanger. You can change
the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Chorus/Flanger
Feedback
Cho/Flng FX Amt
Normal
Wet Invert
Output Mode
–
+
Limiter
Limiter
Gain Adjust
Envelope - Control
LEQ
HEQ
EQ Trim
Chorus/Flanger
LFO: Tri / Sine
LIMITER
a [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
Threshold [dB] –40…0 Sets the level above which the com-
pressor is applied
b [L]Attack 1…10 0 Sets the attack time
Release 1…10 0 Sets the release time
c [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
CHORUS/FLANGER
d [F]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
e [F]Delay Time [msec] 0.0…1350.0 Sets the delay time
Depth 0…10 0 Sets the depth of LFO modulation
Feedback –100…+100 Sets the feedback amount
f [F]EQ Trim 0…10 0 Sets the EQ input level
g [F]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
h [F]Cho/Flng Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the effect balance of the chorus/
anger
Src Of f…Tempo Selects the Wet/Dry modulation
source for the chorus/anger
Amt –100…+100 Sets the Wet/Dry modulation amount
for the chorus/anger
To Next Page
Loading...
Need help?
General
