Mono-Mono Serial (Mono-Mono) |563
95: Exciter - Limiter
This effect combines a mono exciter and a limiter. You can change the order
of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
LEQ HEQ
EQ Trim
Exciter
Exciter
Limiter
Limiter
Gain Adjust
Envelope - Control
EXCITER
a [X]Exciter Blend –100…+100 Sets the intensity (depth) of the
Exciter effect
b [X]Emphasis Frequency 0…70 Sets the frequency range to be
emphasized
c [ X]Trim 0…10 0 Sets the EQ input level
d [X]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
LIMITER
e [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
f [L]Threshold [dB] –40…0 Sets the level above which the
compressor is applied
g [L]Attack 1…10 0 Sets the attack time
Release 1…10 0 Sets the release time
h [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
i Routing
Exciter › Limiter,
Limiter › Exciter
Switches the order of the exciter
and limiter
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
Need help?
General
