506| Effects for the MIDI Sounds
h Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
e: High Damp [%]
e: Low Damp [%]
These parameters set the damping amount of high range and low range. The
tone of the delayed sound becomes darker and lighter as it feeds back.
g: Spread
This parameter sets the pan width of the effect sound. The stereo image is
widest with a value of 50, and the effect sound of both channels is output
from the center with a value of 0.
57: Stereo/CrossDelay
This is a stereo delay, and can by used as a cross-feedback delay effect in
which the delay sounds cross over between the left and right by changing
the feedback routing.
Delay
Delay
Stereo/Cross
Left
Right
Feedback
FX Amt
FX Amt
Stereo In - Stereo Out
Input Level D-mod
Input Level D-mod
High Damp Low Damp
High Damp
Low Damp
Spread
Stereo/Cross
a Stereo/Cross Stereo, Cross Switches between stereo delay and
cross-feedback delay
b L Delay Time [msec] 0.0…1360.0 Sets the delay time for the left chan-
nel
c R Delay Time [msec] 0.0…1360.0 Sets the delay time for the right chan-
nel
To Next Page
Loading...
Need help?
General
