Adding effects |153
Feed the FX2 output back to the FX1 input
You can send the output of the FX2 processor (modulating effect) to the
input of the FX1 processor (reverb). This is preferred, for example, to send a
guitar amp simulator to the reverb.
▪ Use the MFX2 to MFX1 parameter to set the amount of the Master FX2 signal
to be sent back to the Master FX1 processor.
Editing the effects
Choose the effect to edit
1 Go to the Effects > Master 1 or Master 2 page.
2 Use the side tabs on the right to choose an FX Group.
Edit the parameters
▪ See the dedicated chapter for a list of all the Effects parameters and their
meaning.
Mix the direct and effected signal inside the FX processors
▪ Use the W/D (Wet/Dry) parameter to set the balance between the Wet (ef-
fected) and Dry (direct) signal inside the corresponding FX processor.
Choose the Dynamic Modulation Source
▪ Use the Src (Source) parameter to choose a modulation source (physical
controller or MIDI message).
See the chapter dedicated to the Effects for a list of all the Dynamic
Modulation Sources.
To Next Page
Loading...
Need help?
General
