344| Editing the Sounds
Layer and velocity switch
After having selected a key to edit, choose the velocity layer.
Choosing the layer to edit
▪ Use the radio buttons in the Layer Selector & Velocity Sample Switch area
to select the layer to edit. The available number of layers depend on the
Layers pop-up menu above.
Editing the velocity switches
Each of the velocity switch values in the Layer Selector & Velocity Sample
Switch area separates two adjacent layers of the selected key. Notes strick-
en harder than a velocity switch will be played by the layer on the right, while
notes stricken softer are played by the layer on the left.
The first and last values are not editable, and are always 001 and 127 (re-
spectively).
Choosing and setting the drum samples
Use the Drum Sample section to assign a percussive sample to the selected
velocity layer inside the selected key.
Choosing a drum sample
▪ Use the Drum Sample parameters to assign a different drum sample to each
layer. You can use velocity to switch between the available samples. Offset
and Level can be adjusted independently for the various drum samples.
Use the pop-up menus to choose the bank (ROM or RAM). (The RAM bank is
only available in some models).
To Next Page
Loading...
Need help?
General
