512| Effects for the MIDI Sounds
The “Src” parameter sets the modulation source that resets the LFO. For ex-
ample, you can assign Gate as a modulation source so that the sweep always
starts from the specified point.
“L LFO Phase” and “R LFO Phase” set the phase obtained when the left and
right LFOs are reset. In this way, you can create changes in pitch sweep for
the left and right channels individually.
The effect is off when a value of the modulation source specified in the
“Src” parameter is 63 or smaller, and the effect is on when the value is 64
or higher. The LFO is triggered and reset to the “L LFO Phase” and “R LFO
Phase” settings when the value changes from 63 or smaller to 64 or higher.
60: St. Dynamic Delay (Stereo Dynamic Delay)
This stereo delay controls the level of delay according to the input signal
level. You can use this as a ducking delay that applies delay to the sound only
when you play keys at a high velocity or only when the volume level is low.
Delay
Left
Right
Feedback
Spread
FX Amt
FX Amt
Stereo In - Stereo Out
High Damp Low Damp
High Damp
Low Damp
Threshold
Delay
FB
Out
Control Target
Attack, Release
Envelope
+
a Control Target None, Out, FB Selects from no control, output, and
feedback
Polarity +, – Reverses level control
b Threshold 0…10 0 Sets the level to which the effect is ap-
plied
Offset 0…10 0 Sets the offset of level control
c Attack 1…10 0 Sets the attack time of level control
d Release 1…10 0 Sets the release time of level control
e L Delay Time [msec] 0.0…1360.0 Sets the delay time for the left channel
f R Delay Time [msec] 0.0…1360.0 Sets the delay time for the right channel
g Feedback –100…+100 Sets the feedback amount
To Next Page
Loading...
Need help?
General
