Delay |513
h High Damp [%] 0…10 0 Sets the damping amount in the high
range
Low Damp [%] 0…10 0 Sets the damping amount in the low
range
i Spread –100…+100 Sets the width of the stereo image of the
effect sound
j Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Control Target
This parameter selects no level control, delay output control (effect bal-
ance), or feedback amount control.
a: Polarity
b: Threshold
b: Offset
c: Attack
d: Release
The “Offset” parameter specifies the value for the “Control Target” pa-
rameter (that is set to None), expressed as the ratio relative to the param-
eter value (the “Wet/Dry” value with “Control Target”=Output level, or the
“Feedback” value with “Control Target”=Feedback).
When “Polarity” is positive, the “Control Target” value is obtained by multi-
plying the parameter value by the “Offset” value (if the input level is below
the threshold), or equals the parameter value if the input level exceeds the
threshold.
When “Polarity” is negative, Control Target value equals the parameter val-
ue if the input level is below the threshold, or is obtained by multiplying the
parameter value by the “Offset” value if the level exceeds the threshold.
To Next Page
Loading...
Need help?
General
