Korg HAVIAN 30 - Page 499

Modulation and Pitch Shift (Mod./P.Shift) |495
e Feedback
Position
Pre, Post Switches the feedback connection
f Feedback –100…+100 Sets the feedback amount
High Damp [%] 0…10 0 Sets the damping amount in the high range
g Input Level
Dmod [%]
–100…+100 Sets the modulation amount of the input level
Src Off…Tempo Selects the modulation source for the input
level
h Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Mode
This parameter switches the pitch shifter operating mode. With Slow, tonal
quality will not be changed too much. With Fast, the effect becomes a Pitch
Shifter that has a quick response, but may change the tone. Medium is in-
between these two. If you do not need to set too much pitch shift amount, set
this parameter to Slow. If you wish to change the pitch significantly, use Fast.
b: Pitch Shift [1/2tone]
b: Src
b: Amt
c: Fine [cents]
c: Amt
The amount of pitch shift will use the value of the Pitch Shift plus the Fine
value. The amount of modulation will use the b: Amt value plus the c: Amt.
The same Modulation Source is used for both Pitch Shift and Fine.
e: Feedback Position
f: Feedback
When Feedback Position is set to Pre, the pitch shifter output is again input
to the pitch shifter. Therefore, if you specify a higher value for the Feedback
parameter, the pitch will be raised (or lowered) more and more each time
feedback is repeated.