586| Effects for the MIDI Sounds
c Drive Mode Overdrive, Hyper-Gain Switches between overdrive
and hi-gain distortion
d Drive 1…12 0 Sets the degree of distortion
Pre Low-cut 0 …10 Sets the low range cut amount
of the distortion input
e Output Level 0…50 Sets the output level
Src Off…Tempo Selects the modulation source
for the output level
Amt –50…+50 Sets the modulation amount of
the output level
f Low Cutoff [Hz] 2 0…1.0 0 k Sets the center frequency for
Low EQ (shelving type)
Gain [dB] –18…+18 Sets the gain of Low EQ
g Mid1 Cutoff [Hz] 300…10.00k Sets the center frequency for
Mid/High EQ 1 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/
High EQ 1
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 1
h Mid2 Cutoff [Hz] 500…20.00k Sets the center frequency for
Mid/High EQ 2 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/
High EQ 2
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 2
i Direct Mix 0…50 Sets the amount of the dry
sound mixed to the distortion
Speaker Simulation Off, On Switches the speaker simula-
tion on/off
j Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and
dry signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
Need help?
General
