Delay |517
h High Damp [%] 0…10 0 Sets the damping amount in the high
range
Low Damp [%] 0 …10 0 Sets the damping amount in the low
range
i Saturation 0…10 0 Sets the distortion amount
j Input Trim 0…10 0 Sets the input gain
Pre Tone 0 …10 0 Sets the tone of the input
k Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch varia-
tion will occur
Wow Flutter depth 0…10 0 Sets the depth of pitch variation
l Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Delay (Tap1) [msec]
a: Src
a: Amt
b: Tap2 Position [%]
b: Tap3 Position [%]
The delay time for Tap 2 and 3 is specified as a proportion (%) relative to
“Delay (Tap1).” Even if you use dynamic modulation to control “Delay (Tap1),”
Tap 2 and 3 will change at the same proportion.
d: FB Amt
e: FB Amt
f: FB Amt
g: Feedback
The feedback output from Tap 1, 2, and 3 is mixed according to the “FB Amt,”
and then the final amount of feedback is specified by “Feedback.”
To Next Page
Loading...
