DMS (Dynamic Modulation Sources) |401
Gate1, Gate1+Dmpr (Gate1+Damper)
The effect is at maximum during note-on, and will stop when all keys are re-
leased. With Gate1 + Dmpr, the effect will remain at maximum even after the
keys are released, as long as the damper (sustain) pedal is pressed.
Gate1
Note
Dmpr
1
2
3
1
2
3
Damper Pedal
Gate1+Dmpr
Time
On
Off
Gate2, Gate2+Dmpr (Gate2+Damper)
This is essentially the same as for Gate 1 or Gate 1 + Dmpr. However when
Gate 2 or Gate 2 + Dmpr are used as a dynamic modulation source for the
EG, a trigger will occur at each note-on. (In the case of Gate 1 and Gate 1 +
Dmpr, the trigger occurs only for the first note-on.)
Gate2
Note
Dmpr
1
2
3
1
2
3
Damper Pedal
Gate2+Dmpr
Time
On
Off
To Next Page
Loading...
