EQ and Filters (EQ/Filter) |423
g MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note
…
Selects the type of notes that specify
the LFO speed
Times x1…x32 Sets the number of notes that specify
the LFO speed
h Output Level 0…10 0 Sets the output level of the effect sound
Src Of f…Tempo Selects the modulation source that will
control the effect output level
Amt –100…+100 Sets the modulation amount of the ef-
fect output level
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Shape
This parameter specifies the sweep curve of the wah. It applies to all control
via auto-wah, modulation source, and LFO, and lets you adjust subtle nu-
ances of the wah effect.
a: Mode
b: Frequency Bottom
b: Frequency Top
c: Resonance Bottom
c: Resonance Top
If Mode=Preset, this simulates a vintage wah pedal. In this case, internally
fixed values are used for Frequency Bottom/Top and Resonance Bottom/
Top, and these settings will be ignored. The settings for Frequency Bottom/
Top and Resonance Bottom/Top are valid if Mode=Custom.
To Next Page
Loading...
Need help?
General
