Korg HAVIAN 30 - Page 469

Chorus, Flanger, and Phaser (Cho/Fln Phaser) |465
e Manual 0…10 0 Sets the frequency to which the effect is
applied
Src Off…Tempo Selects the modulation source for the LFO
modulation
Amt –100…+100 Sets the modulation amount of the LFO
modulation
f Depth 0…10 0 Sets the depth of LFO modulation
Src Off…Tempo Selects the modulation source for the LFO
modulation depth
Amt –100…+100 Sets the modulation amount of the LFO
modulation depth
h Resonance –100…+100 Sets the resonance amount
High Damp [%] 0…10 0 Sets the resonance damping amount in
the high range
j Wet/Dry -Wet, -1:99…
Dry…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
h: Resonance
i: Wet/Dry
The peak shape of the positive and negative Feedback value is different. The
harmonics will be emphasized when the effect sound is mixed with the dry
sound, if you set a positive value for both “Resonance” and “Wet/Dry”, and
if you set a negative value for both “Resonance” and “Wet/Dry”.
h: High Damp [%]
This parameter sets the amount of damping of the resonance in the high
range. Increasing the value will cut high-range harmonics.