Modulation and Pitch Shift (Mod./P.Shift) |503
g Mic Distance 0…10 0 Sets the distance between the microphone
and rotary speaker
Mic Spread 0…10 0 Sets the angle of left and right microphones
h Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Mode
This parameter sets how the modulation source switches between rotation
and stop.
When Mode = Toggle, the speaker rotates or stops alternately each time you
press the pedal or move the joystick. Via MIDI, rotation will switch between
start and stop each time the modulation amount exceeds 64.
When Mode = Moment, the speaker rotates by default, and stops only when
you press the pedal or move the joystick. Via MIDI, modulation values above
64 make the speaker rotate, and values below 64 make it stop.
b: Speed Switch
This parameter controls how the rotation speed (slow and fast) is switched
via the modulation source.
When Mode = Toggle, the speed will switch between slow and fast each time
you press the pedal or move the joystick. Via MIDI, the speed will switch each
time the modulation amount exceeds 64.
When Mode = Moment, the speed is usually slow. It becomes fast only when
you press the pedal or move the joystick. Via MIDI, modulation values above
64 set the speed to Fast, and values below 64 set it to Slow.
c: Manual Speed Ctrl
If you wish to control the rotation speed manually, instead of switching be-
tween Slow and Fast, select a modulation source in the Manual Speed Ctrl
parameter. If you don’t want to use manual control, set this to Off.
To Next Page
Loading...
Need help?
General
