530| Effects for the MIDI Sounds
d High Damp [%] 0…10 0 Sets the damping amount in the high
range
Low Damp [%] 0…10 0 Sets the damping amount in the low
range
e LFO Waveform Triangle, Sine Selects the LFO Waveform
Shape –100…+100 Changes the curvature of the LFO
Waveform
LFO Phase –180…+180 Sets the LFO phase difference between
the left and right
f Panning Freq [Hz] 0.02…20.00 Sets the panning speed
g MIDI Sync Off, On When this is on, the pan LFO speed is set
by BPM, Base Note, and Times, instead
of Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individ-
ual effect
Base Note
…
Selects the type of notes to specify the
delay time for the panning speed
Times x1…x32 Sets the number of notes to specify the
delay time for the panning speed
h Panning Depth 0…10 0 Sets the panning width
Src Off…Tempo Selects the modulation source for the
panning width
Amt –100…+100 Set the modulation amount of the panning
width
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
