532| Effects for the MIDI Sounds
g Tap2 Level 0 …10 0 Sets the Tap2 output level
Pan L, 1…99, R Sets the stereo image of tap2
FB Amt –100…+100 Sets the Tap2 feedback amount
h Tap3 Level 0…10 0 Sets the Tap3 output level
Pan L, 1…99, R Sets the stereo image of tap3
FB Amt –100…+100 Sets the Tap3 feedback amount
i Feedback 0…10 0 Sets the amount of feedback for Taps 1, 2,
and 3
Src Of f…Tempo Selects the modulation source of feedback
amount
Amt –100…+100 Sets the depth by which feedback amount
will be modulated
j High Damp [%] 0 …10 0 Sets the damping amount in the high range
Low Damp [%] 0…10 0 Sets the damping amount in the low range
k Saturation 0…10 0 Sets the distortion amount
l Input Trim 0…10 0 Sets the input gain
Pre Tone 0…10 0 Sets the tone of the input
m Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation
will occur
Wow Flutter
depth
0…10 0 Sets the depth of pitch variation
n Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Of f…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Tap1 Dmod Src
b: Tap1 Delay Note
b: Times
c: Tap1 Dmod Note
c: Times
If “Tap1 Dmod Src” is Off or the selected modulation is at 0, the delay time
will be the length specified by “Tap1 Delay Note” and “Times.”
If “Tap1 Dmod Src” is other than Off, the delay time will change so that it
will be as specified by “Tap1 Dmod Note” and “Times” when the maximum
modulation is reached.
To Next Page
Loading...
Need help?
General
