Mono-Mono Serial (Mono-Mono) |561
LIMITER
a [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
Threshold [dB] –40…0 Sets the level above which the compres-
sor is applied
b [L]Attack 1…10 0 Sets the attack time
Release 1…10 0 Sets the release time
c [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
MULTITAP DELAY
d [D]Tap1 Time [msec] 0.0…1360.0 Sets the Tap1 delay time
Tap1 Level 0…10 0 Sets the Tap1 output level
e [D]Tap2 Time [msec] 0.0…1360.0 Sets the Tap2 delay time
Feedback –100…+100 Sets the Tap2 feedback amount
f [D]High Damp [%] 0…10 0 Sets the damping amount in the high
range
g [D]Mt.Delay Wet/Dry Dry,
1:99…99:1,
Wet
Sets the multitap delay effect balance
Src Off…Tempo Selects the multitap delay’s Wet/Dry
modulation source
Amt –100…+100 Sets the multitap delay’s Wet/Dry modu-
lation amount
h Routing
Limiter ›
Mt.Delay,
Mt.Delay ›
Limiter
Switches the order of the limiter and mul-
titap delay
i Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
Need help?
General
