Double Size |599
f Horn/Rotor
Balance
Rotor, 1…99,
Horn
Sets the volume balance between
the high-range horn and low-range
rotor
Manual SpeedCtrl Off…Tempo Sets a modulation source for direct
control of rotation speed
g Horn
Acceleration
0…10 0 Sets how quickly the horn rotation
speed changes
Horn Ratio Stop, 0.50…2.00 Adjusts the (high-frequency) horn ro-
tation speed. Standard value is 1.00.
“Stop” stops the rotation
h Rotor
Acceleration
0…10 0 Sets how quickly the rotor speed
changes
Rotor Ratio Stop, 0.50…2.00 Adjusts the (low-frequency) rotor ro-
tation speed. Standard value is 1.0.
“Stop” stops the rotation
i Mic Distance 0…10 0 Distance between the microphone
and rotary speaker
Mic Spread 0…10 0 Angle of left and right microphones
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
a: Sw
This parameter determines how to switch on/off the overdrive via a modula-
tion source.
When “Sw” = Toggle, overdrive is turned on/off each time the pedal or joy-
stick is operated.
Overdrive will be switched on/off each time the value of the modulation
source exceeds 64.
When “Sw” = Moment, overdrive is applied only when you press the pedal or
operate the joystick.
Only when the value for the modulation source is 64 or higher, the over-
drive effect is applied.
To Next Page
Loading...
Need help?
General
