Double Size |609
e R Feedback –100…+100 Sets the feedback amount for the
right channel
R Amt –100…+100 Sets the modulation amount of the
right channel feedback
f High Damp [%] 0…10 0 Sets the damping amount in the high
range
g Low Damp [%] 0 …10 0 Sets the damping amount in the low
range
h Input Level Dmod [%] –100…+100 Sets the modulation amount of the
input level
Src Off…Tempo Selects the modulation source for the
input level
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
a: Time Over? L, R
You can set the delay time up to 5,460msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.
To Next Page
Loading...
