Sub-GHz radio (SUBGHZ) RM0453
182/1461 RM0453 Rev 1
5.8.4 Sub-GHz radio configuration commands
Set_PacketType() command
Set_PacketType(PktType) allows the selection of packet frame format. This command
must be the first command of a sub-GHz radio configuration sequence.
Changing from one sub-GHz radio configuration to another is done using
Set_PacketType(). The parameters from the previous sub-GHz radio configuration are
lost. The switch from one configuration mode to another is only accepted in Standby mode.
Get_PacketType() command
Get_PacketType(Status, PktType) returns information on the selected packet frame
format.
Changing from one sub-GHz radio configuration to another is done using
Set_PacketType(). The parameters from the previous sub-GHz radio configuration are
lost. The switch from one configuration mode to another is only accepted in Standby mode.
01
Opcode PktType
ww
byte 0 bits 7:0 Opcode: 0x8A.
byte 1 bits 7:2 Reserved, must be kept at reset value.
bits 1:0 PktType[1:0]: Packet type definition
0: FSK generic packet type
1: LoRa packet type
2: BPSK packet type
3: MSK generic packet type
Other: reserved
012
Opcode Status[7:0] PktType
wr r
byte 0 bits 7:0 Opcode: 0x11
byte 1 bits 7:0 Status[7:0]: see Get_Status() command
byte 2 bits 7:2 Reserved, must be kept at reset value.
bits 1:0 PktType[1:0]: Packet type definition
0: FSK generic packet type
1: LoRa packet type
2: BPSK packet type
3: MSK generic packet type
Others: reserved
To Next Page
Loading...
Need help?
General
