EasyManuals Logo

ST STM32WL5 Series User Manual

ST STM32WL5 Series
1461 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #926 background imageLoading...
Page #926 background image
General-purpose timers (TIM16/TIM17) RM0453
926/1461 RM0453 Rev 1
27.3.13 One-pulse mode
One-pulse mode (OPM) is a particular case of the previous modes. It allows the counter to
be started in response to a stimulus and to generate a pulse with a programmable length
after a programmable delay.
Starting the counter can be controlled through the slave mode controller. Generating the
waveform can be done in output compare mode or PWM mode. One-pulse mode is selected
by setting the OPM bit in the TIMx_CR1 register. This makes the counter stop automatically
at the next update event UEV.
A pulse can be correctly generated only if the compare value is different from the counter
initial value. Before starting (when the timer is waiting for the trigger), the configuration must
be:
CNT < CCRx ARR (in particular, 0 < CCRx)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32WL5 Series and is the answer not in the manual?

ST STM32WL5 Series Specifications

General IconGeneral
BrandST
ModelSTM32WL5 Series
CategoryMicrocontrollers
LanguageEnglish

Related product manuals