Cisco ONS 15454 SDH - Page 22

Figures
vi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Figure 19-11 Setting Roll Routing Preferences 19-37
Figure 19-12 Reinitialization Tool 19-47
Figure 20-1 Invoking a Protection Operation on a Three-Node MS-SPRing 20-3
Figure 20-2 Defining the Circuit Source on an E3-12 Card 20-9
Figure 20-3 Unscrewing the FMEC Cover 20-11
Figure 20-4 Removing the ONS 15454 SDH FMEC Cover 20-12
Figure 20-5 GBIC Installation (with Clips) 20-31
Figure 20-6 Connecting Fiber to a Four-Node SNCP 20-34
Figure 20-7 Connecting Fiber to an Eight-Node SNCP DRI 20-35
Figure 20-8 Connecting Fiber to a Six-Node Integrated SNCP DRI 20-36
Figure 20-9 Connecting Fiber to a Four-Node, Two-Fiber MS-SPRing 20-38
Figure 20-10 Connecting Fiber to a Four-Node, Four-Fiber MS-SPRing 20-39
Figure 20-11 Ether Ports on the Card View Performance Window 20-56
Figure 20-12 POS Ports on the Card View Performance Window 20-58
Figure 20-13 Verifying Pass-Through VC4s 20-64
Figure 21-1 Viewing STM-N Card Performance Monitoring Information 21-3
Figure 21-2 Network View Alarm Profiles Window 21-7
Figure 21-3 Store Profile(s) Dialog Box 21-8
Figure 21-4 Port Alarm Profile for an OC3 IR/STM1 SH 1310-8 Card 21-10
Figure 21-5 Select Node/Profile Combination For Delete Dialog Box 21-11
Figure 21-6 Alarm Filter Dialog Box General Tab 21-13
Figure 21-7 Alarm Filter Dialog Box Conditions Tab 21-14
Figure 21-8 Port Status on the LCD Panel 21-18
Figure 21-9 Creating Ethernet RMON Thresholds 21-28
Figure 21-10 Line Drop-down List for an STM-16 Card 21-35
Figure 21-11 FC_MR-4 Statistics in the Card View Performance Window 21-37
Figure 21-12 FC_MR-4 Utilization in the Card View Performance Window 21-38
Figure 21-13 FC_MR-4 History in the Card View Performance Window 21-39