LVD is OFF (Use RESETB External reset input for the pin)
Note 1 You must write 1 to bit4.
2. When the supply voltage rises, the reset state must be maintained by the voltage detection circuit or external reset
before the supply voltage reaches the working voltage range shown in the AC characteristics of the data sheet;
When the supply voltage drops, it must be reset through sleep mode transfer, voltage detection circuitry, or
external reset before the supply voltage drops below the operating voltage range.
The operating voltage range depends on the setting of the user option byte (000C2H).
Note 1 ×: Ignore
2. For details of the LVD circuit, please refer to Chapter 2 3 Voltage Detection Circuit.
3. The detection voltage is TYP Value. For details, please refer to the LVD circuit characteristics in the data sheet.
To Next Page
Loading...