Enterasys b5 - Set Tftp Timeout

set tftp timeout
3-46 Basic Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
TheTFTPtimeoutvaluecanbesetwiththesettftptimeoutcommand.TheTFTPretryvaluecan
besetwiththesettftpretrycommand.
Example
Thisexampleshowstheoutputofthiscommand.
B5(ro)->show tftp settings
TFTP packet timeout (seconds): 2
TFTP max retry: 5
set tftp timeout
UsethiscommandtoconfigurehowlongTFTPwillwaitforareplyofeitheranacknowledgement
packetoradatapacketduringadatatransfer.
Syntax
set tftp timeout seconds
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthetimeoutperiodto4seconds.
B5(rw)->set tftp timeout 4
seconds Specifiesthenumberofsecondstowaitforareply.Thevalidrangeis
from1to30seconds.Defaultvalueis2seconds.