Enterasys b5

clear nodealias config
Enterasys B5 CLI Reference 14-41
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Uponpacketreception,nodealiasesaredynamicallyassignedtoportsenabledwithanalias
agent,whichisthedefaultsettingonEnterasysB5devices.Nodealiasescannotbestatically
created,butcanbedeletedusingthecommand“clearnodealiasconfig”(page 14‐41).
Itʹsimportanttomakesurethatinter‐
switchlinksarenotlearningnode/aliasinformation,asit
wouldslowdownsearchesbytheNetSightCompassandASMtoolsandgiveinaccurateresults.
Example
Thisexampleshowshowtodisablethenodealiasagentonge.1.3:
B5(su)->set nodealias disable ge.1.3
clear nodealias config
Usethiscommandtoresetnodealiasstatetoenabledandclearthemaximumentriesvalue.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthenodealiasconfigurationonge.1.3:
B5(su)->clear nodealias config ge.1.3
port‐string Specifiestheport(s)onwhichtoresetthenodealiasconfiguration.