Enterasys b5

disconnect
Enterasys B5 CLI Reference 14-17
B5(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
UsethiscommandtocloseanactiveconsoleportorTelnetsessionfromtheswitchCLI.
Syntax
disconnect {ip-addr | console}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtocloseaTelnetsessiontohost134.141.192.119:
B5(su)->disconnect 134.141.192.119
Thisexampleshowshowtoclosethecurrentconsolesession:
B5(su)->disconnect console
show netstat
Usethiscommandtodisplaynetworklayerstatistics.
Syntax
show netstat [icmp | ip | routes | stats | tcp | udp]
Parameters
ip‐addr SpecifiestheIPaddressoftheTelnetsessiontobedisconnected.This
addressisdisplayedintheoutputshownin“showusers”onpage 12‐15.
console Closesanactiveconsoleport.
icmp (Optional)ShowsInternetControlMessageProtocol(ICMP)statistics.
ip (Optional)ShowsInternetProtocol(IP)statistics.
routes (Optional)ShowstheIProutingtable.
stats (Optional)ShowsallstatisticsforTCP,UDP,IP,andICMP.
tcp (Optional)ShowsTransmissionControlProtocol(TCP)statistics.
udp (Optional)ShowsUserDatagramProtocol(UDP)statistics.