Enterasys b5

clear arpinspection filter
Enterasys B5 CLI Reference 17-29
B5(su)->clear arpinspection vlan 5 logging
B5(su)->show arpinspection vlan 5
Source MAC Validation Disabled
Destination MAC Validation Disabled
IP Address Validation Disabled
Vlan Configuration Log Invalid ACL Name Static flag
---- ------------- ----------- -------------------------------- -----------
5 Disabled Disabled staticARP Enabled
clear arpinspection filter
UsethiscommandtoremoveanARPACLfromaVLAN orfromtheswitch,ortoremovea
permitrulefromanexistingACL,ortochangethestatusofstaticmappingtodisabled.
Syntax
clear arpinspection filter name [permit ip host sender-ipaddr mac host
sender-macaddr] | [vlan vlan-range [static]
Parameters
Defaults
Ifonlythenameisspecified,theACLisdeletedfromtheswitch.
Mode
Switchcommand,read‐write.
Usage
Youcanusethiscommandto:
•RemoveaconfiguredARPACLfromtheswitch,or
•RemoveapermitrulefromaconfiguredARPACL,or
•RemovetheassociationofanARPACLwithaVLANorVLANs,or
•DisablestaticmappingofanARPACLassociatedwithaVLANorVLANs.
Usethe
setarpinspectionfiltercommandtocreateandassignanARPACL.
Usetheshowarpinspectionaccess‐listcommandtodisplaycurrentlyconfiguredARPACLs.
name SpecifiesthenameoftheARPACL.
permit (Optional)Specifiesthatapermitruleisbeingdeleted.
iphostsender‐ipaddr SpecifiestheIPaddressintherulebeing
deleted.
machost
sender‐macaddr
SpecifiestheMACaddressintherulebeingdeleted.
vlanvlan‐range (Optional)SpecifiestheVLANorVLANstowhichthiscommand
shouldapply.RemovetheACLfromtheVLAN,ifstaticisnotspecified
also.
static (Optional)SpecifiesthatstaticmappingshouldbedisabledforthisARP
ACL
forthespecifiedVLANorVLANs.