Enterasys b5

show policy maptable
22-54 Authentication and Authorization Configuration
IfVLANauthorizationisnotenabled,thetunnelattributesareignored.
When Policy Maptable Response is “Policy”
WhentheswitchisconfiguredtouseonlyFilter‐IDattributes,bysettingthesetpolicymaptable
commandresponseparametertopolicy:
•IftheFilter‐IDattributesarepresent,thesp ecifiedpolicyprofilewillbeappliedtothe
authenticatinguser.IfnoFilter‐IDattributesarepresent,orifthepolicy
IDisunknownor
invalid,thedefaultpolicy(ifitexists)willbeapplied.
•Ifthetunnelattributesarepresent,theyareignored.NoVLAN‐to‐policymappingwilloccur.
Onswitchesthatsupportpolicy,thedefaultmaptableresponsemodeispolicy.Onswi tchesthat
donotsupportpolicy,thedefault
maptableresponsemodeistunnel.
When Policy Maptable Response is “Tunnel”
Whentheswitchisconfiguredtouseonlytunnelattributes,bysettingthesetpolicymaptable
commandresponseparametertotunnel,andifVLANauthorizationisenabledbothgloballyand
ontheauthenticatinguser’sport:
•Ifthetunnelattributesarepresent,thespecifiedVLANwillbeappliedtotheauthenticating
user.
NoVLAN‐to‐policymappingwilloccur.
•Ifthetunnelattributesarenotpresent,the defaultpolicyVLANwillbeappliedifitexists.
Otherwise,theportVLANwillbeapplied.
•IftheFilter‐IDattributesarepresent,theyareignored.
IfVLANauthorizationisnotenabled,theuserwillbe
allowedontotheportwiththedefault
policy,ifitexists.Ifnodefaultpolicyexists,theportVLANwillbeapplied.
Onswitchesthatsupportpolicy,thedefaultmaptableresponsemodeispolicy.Onswi tchesthat
donotsupportpolicy,thedefaultmaptableresponsemodeistunnel.
Commands
show policy maptable
UsethiscommandtodisplayinformationaboutthecurrentVLAN‐to‐policymappingtableand
theswitch’spolicymaptableresponse setting.
Syntax
show policy maptable [vlan-list]
Parameters
For information about... Refer to page...
show policy maptable 22-54
set policy maptable 22-55
clear policy maptable 22-56
vlan‐list (Optional)SpecifiestheVLANorlistofVLANsforwhichtodisplaythe
VLAN‐to‐policysettings.