Enterasys b5

clear cos port-resource flood-ctrl
11-30 Policy Classification Configuration
clear cos port-resource flood-ctrl
Usethiscommandtoclearfloodcontrolportresourcestodefaultvalues.
Syntax
clear cos port-resource flood-ctrl {all | group-type-index {unicast | multicast |
broadcast | all [rate]}}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleclearstheunicastportresourceforportgroup1.0todefaultvalues.
B5(su)->clear cos port-resource flood-ctrl 1.0 unicast
set cos reference
UsethiscommandtosettheClassofServiceinboundratelimitingreferenceconfiguration.
Syntax
set cos reference irl group-type-index reference rate-limit irl-index
Parameters
all Clearallfloodcontrolresourcesforallportgroups.
group‐type‐index Specifiesaportgroup/typeindex.Validentriesareintheformof
group#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0to1,althoughonly porttype
0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
unicast Clearunicastportresourcesforthespecifiedportgroup.
multicast Clearmulticastportresourcesforthespecifiedportgroup.
broadcast Clearbroadcastportresourcesforthespecifiedportgroup.
all Clearallfloodcontrolportresourcesforthe
specifiedportgroup.
rate (Optional)Clearthedataratelimiterofthespecifiedtypeofport
resourcetothedefault(noneordisabled).
irl SpecifiesthatanIRLreferenceisbeingconfigured.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0to1,althoughonly
porttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.