Enterasys b5

set lacp singleportlag
7-52 Port Configuration
set lacp singleportlag
UsethiscommandtoenableordisabletheformationofsingleportLAGs.
Syntax
set lacp singleportlag {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
WhensingleportLAGsareenabled,LinkAggregrationGroupscanbeformedwhenonlyone
portisreceivingprotocoltransmissionsfromapartner.Whenthissettingisdisabled,twoormore
portsarerequiredtoformaLAG.
ThissettinghasnoeffectonexistingLAGscreatedwithmultiplememberports.
Italsodoesnot
preventpreviouslyformedLAGsfromcomingupaftertheyhavegonedown,aslongasany
previousLAGmemberportscomeupconnectedtothesameswitchasbeforetheLAGwent
down.
Example
ThisexampleenablestheformationofsingleportLAGs:
B5(su)->set lacp singleportlag enable
clear lacp singleportlag
UsethiscommandtoresetthesingleportLAGfunctionbacktothedefaultstateofdisabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
disable|enable EnablesordisablestheformationofsingleportLAGs.