Enterasys b5

clear sflow interface
24-16 sFlow Configuration
None.
Defaults
None.
Mode
Switchmode,read‐only.
Example
Thisexampledisplaystheoutputofthiscommand.Inthiscase,theIPaddressassignedto
loopbackinterface1willbeusedasthesourceIPaddressofthesFlowAgent.
B5(rw)->show sflow interface
loopback 1 192.168.10.1
clear sflow interface
UsethiscommandtoclearthemanagementinterfaceusedbythesFlowAgentbacktothedefault
oftheHostVLAN.
Syntax
clear sflow interface
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThiscommandreturnsthemanagmentinterfaceusedbythesFlowAgentbacktothedefaultof
theHostVLAN.
B5(rw)->show sflow interface
vlan 100 192.168.10.1
B5(rw)->clear sflow interface
B5(rw)->