show sflow receivers
24-6 sFlow Configuration
IP Address: 10.1.2.117
Address Type IPv4
Port 6343
Datagram Version 5
Maximum Datagram Size 1400
Theî ±followingî ±tableî ±describesî ±theî ±outputî ±fields.
Table 24-2 show sflow receivers Output Descriptions
Output... What it displays...
Receiver Index Index number of a specific Collector entry in the sFlow Receivers
Table. Up to 8 Collectors may be configured.
Owner String Identity string of the Collector. An empty string indicates that the
entry is unclaimed and cannot be assigned to a sampler or poller
instance. The owner string is configured with the set sflow receiver
owner command.
Time Out The time remaining, in seconds, before the sampler or poller is
released and stops sending samples to this receiver/Collector.
The timeout value is configured with the set sflow receiver owner
command.
IP Address The IP address of this receiver/Collector. The IP address is
configured with the set sflow receiver ip command.
Address Type Whether the Collector IP address is IPv4 or IPv6.
Port The UDP port number on this receiver/Collector to which sample
datagrams should be sent. The default value is 6343, which can
be changed with the set sflow receiver port command.
Datagram Version Specifies the sFlow version used for formatting the sample
datagrams.
Max Datagram Size The maximum number of data bytes that can be sent in a single
sample datagram to this receiver/Collector. The default value is
1400 bytes, which can be changed with the set sflow receiver
maxdatagram command.
To Next Page
Loading...
General