clear lldp
Enterasys B5 CLI Reference 6-31
AfteryouconfigureNetworkPolicyTLVs,youmustalsoconfiguretheporttosendtheNetwork
PolicyTLVwiththesetlldpporttx‐tlvcommand.
Example
ThisexampleconfiguresthevoiceapplicationTLVonportge.2.1andthenconfigurestheportto
sendtheNetworkPolicyTLV.
B5(rw)->set lldp port network-policy voice state enable tag tagged vlan dot1p
ge.2.1
B5(rw)->set lldp port tx-tlv med-pol ge.2.1
clear lldp
UsethiscommandtoreturnLLDPparameterstotheirdefaultvalues.
Syntax
clear lldp {all | tx-interval | hold-multiplier | trap-interval | med-fast-repeat}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplereturnsthetransmitintervaltothedefaultvalueof30seconds.
B5(rw)->clear lldp tx-interval
clear lldp port status
Usethiscommandtoreturntheportstatustothedefaultvalueofboth(bothtransmittingand
processingreceivedLLDPDUsareenabled).
Syntax
clear lldp port status port-string
all ReturnsallLLDPconfigurationparameterstotheirdefaultvalues,
includingportLLDPconfigurationparameters.
tx‐interval ReturnsthenumberofsecondsbetweentransmissionsofLLDP
frames.tothedefaultof30seconds.
hold‐multiplier Returnsthemultipliertoapplytothetransmitintervaltodetermin e
thetime‐to‐livevaluetothedefault
valueof4.
trap‐interval ReturnstheminimumtimebetweenLLSPtraptransmissionstothe
defaultvalueof5seconds.
med‐fast‐repeat ReturnsthenumberoffaststartLLDPDUstobesentwhenanLLDP‐
MEDendpointdeviceisdetectedtothedefaultof3.
To Next Page
Loading...
General