Enterasys b5 User Manual

set lldp port network-policy
6-30 Discovery Protocol Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThisfeatureallowsadministratorstoquicklyprovisionLLDPend‐pointsviatheswitch.LLDP
clientswillusetheseLLDPnetworkpolicyparametersfortrafficoriginatingfromtheend‐point.
AsdescribedintheANSI/TIAS tandardsdocument1057,theNetworkPolicyTLVis“intendedfor
usewithapplicationsthathavespecificreal‐
timenetworkpolicyrequirements,suchasinteractive
voiceand/orvideoservices”andshouldbeimplementedonlyondirectlinksbetweennetwork
connectivitydevicesandendpointdevices.RefertotheANSI/TIAStandardsdocument1057for
descriptionsoftheapplicationtypes.
guest‐voice Configurestheguestvoiceapplication.
guest‐voice‐signaling Configurestheguest
voicesignalingapplication.
Thisapplicationwillnotbeadvertisediftheguest‐voice
applicationisconfiguredwiththesameparameters.
softphone‐voice Configuresthesoftphonevoiceapplication.
video‐conferencing Configuresthevideoconferencingapplication.
streaming‐video Configuresthestreamingvideoapplication.
video‐signaling Configuresthevideosignalingapplication.
Thisapplicationwillnotbeadvertisedif
thevideo‐conferencing
applicationisconfiguredwiththesameparameters.
stateenable|disable (Optional)Enablesordisablesadvertisingtheapplication
informationbeingconfigured.
tagtagged|untagged (Optional)Indicateswhethertheapplicationbeingconfiguredis
usingataggedoruntaggedVLAN.Ifuntagged,boththeVLANID
andtheCoSpriority
fieldsareignoredandonlytheDSCPvalue
hasrelevance.
vidvlan‐id|dot1p (Optional)VLANidentifierfortheport.Thevalueofvlan‐idcan
rangefrom1to4093.
Usedot1pifthedeviceisusingprioritytaggedframes,meaning
thatonlytheIEEE802.1Dprioritylevelissignificant
andthe
defaultPVIDoftheingressportisused.
coscos‐value (Optional)SpecifiestheLayer2prioritytobeusedforthe
applicationbeingconfigured.Thevaluecanrangefrom0to7.A
valueof0representsuseofthedefaultpriorityasdefinedinIEEE
802.1D.
dscpdscp
‐value (Optional)SpecifiestheDSCPvaluetobeusedtoprovideDiffserv
nodebehaviorfortheapplicationbeingconfigured.Thevaluecan
rangefrom0to63.Avalueof0representsuseofthedefaultDSCP
valueasdefinedinRFC2475.
port‐string Specifiestheportorrangeofports
tobeaffected.

Enterasys b5 Specifications

General

Brand	Enterasys
Model	b5
Category	Other
Language	English