Enterasys b5

set spantree bridgeprioritymode
Enterasys B5 CLI Reference 9-11
set spantree bridgeprioritymode
UsethiscommandtosettheSpanningTreebridgeprioritymodeto802.1D(legacy)or802.1t.
Syntax
set spantree bridgeprioritymode {8021d | 8021t}
Parameters
Defaults
None
Mode
Switchcommand,read‐write.
Usage
Themodeaffectstherangeofpriorityvaluesusedtodeterminewhichdeviceisselectedasthe
SpanningTreerootasdescribedinsetspantree priority(“setspantreepriority”onpage 9‐17).The
defaultfortheswitchistouse802.1tbridgeprioritymode.
Example
Thisexampleshowshowtosetthebridgeprioritymodeto802.1D:
B5(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
UsethiscommandtoresettheSpanningTreebridgeprioritymodetothedefaultsettingof802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
8021d Setsthebridgeprioritymodetouse802.1D(legacy)values,whichare0‐
65535.
8021t Setsthebridgeprioritymodetouse802.1tvalues,whichare0to61440,in
incrementsof4096.Valueswillautomaticallyberoundedupordown,
dependingonthe802.1tvaluetowhich
theenteredvalueisclosest.
Thisisthedefaultbridgeprioritymode.