Enterasys b5

clear tftp timeout
Enterasys B5 CLI Reference 3-47
clear tftp timeout
UsethiscommandtoresettheTFTPtimeoutvaluetothedefaultvalueof2seconds.
Syntax
clear tftp timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthetimeoutvaluetothedefaultof2seconds.
B5(rw)-> clear tftp timeout
set tftp retry
UsethiscommandtoconfigurehowmanytimesTFTPwillresendapacket,eitheran
acknowledgementpacketoradatapacket.
Syntax
set tftp retry retry
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetstheretrycountto3.
B5(rw)->set tftp retry 3
retry Specifiesthenumberoftimesapacketwillbe resent.Thevalidrangeis
from1to1000.Defaultvalueis5retries.