Enterasys b5 - Clear Ip Address

clear ip address
Enterasys B5 CLI Reference 3-11
Parameters
Defaults
Ifnotspecified,ip‐maskwillbesettothenaturalmaskoftheip‐addressandip‐gatewaywillbesetto
theip‐address.
Mode
Switchcommand,read‐write.
Usage
Parametersmustbeenteredintheordershown(hostIP,thenmask,thengateway)forthe
commandtobeaccepted.
Example
ThisexampleshowshowtosetthesystemIPaddressto10.1.10.1withamaskof255.255.128.0:
B5(su)->set ip address 10.1.10.1 mask 255.255.128.0
clear ip address
UsethiscommandtoclearthesystemIPaddress.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthesystemIPaddress:
B5(rw)->clear ip address
ip‐address SetstheIPaddressforthesystem.ForEnterasysB5systems,thisistheIP
addressofthemanagementswitchasdescribedin“AboutEnterasysB5
SwitchOperationinaStack”onpage2‐1.
maskip‐mask (Optional)Setsthesystem’ssubnetmask.
gatewayip‐gateway (Optional)Setsthe
system’sdefaultgateway(next‐hopdevice).