Enterasys b5

set spantree maxage
Enterasys B5 CLI Reference 9-19
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtogloballyresettheSpanningTreehellotime:
B5(su)->clear spantree hello
set spantree maxage
Usethiscommandtosetthebridgemaximumagingtime.
Syntax
set spantree maxage agingtime
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thebridgemaximumagingtimeisthemaximumtime(inseconds)adevicecanwaitwithout
receivingaconfigurationmessage(bridge“hello”)beforeattemptingtoreconfigure.Alldevice
ports(exceptfordesignatedports)shouldreceiveconfigurationmessagesatregularintervals.
AnyportthatagesoutSTPinformationprovidedinthelast
configurationmessagebecomesthe
designatedportfortheattachedLAN.Ifitisarootport,anewrootportisselectedfromamong
thedeviceportsattachedtothenetwork.
Example
Thisexampleshowshowtosetthemaximumagingtimeto25seconds:
B5(su)->set spantree maxage 25
agingtime Specifiesthemaximumnumberofsecondsthatthesystemretainsthe
informationreceivedfromotherbridgesthroughSTP.Validvaluesare 6‐
40.