Enterasys b5 - Set Pwa Ipaddress; Set Pwa Protocol

To Next Page

To Previous Page

set pwa ipaddress

Enterasys B5 CLI Reference 22-73

set pwa ipaddress

UsethiscommandtosetthePWAIPaddress.ThisistheIPaddressoftheendstationfromwhich

PWAwillpreventnetworkaccessuntiltheuserisauthenticated.

Syntax

set pwa ipaddress ip-address

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosetaPWAIPaddressof1.2.3.4:

B5(su)->set pwa ipaddress 1.2.3.4

set pwa protocol

Usethiscommandtosettheportwebauthenticationprotocol.

Syntax

set pwa protocol {chap | pap}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosetathePWAprotocoltoCHAP:

B5(su)->set pwa protocol chap

ip‐address SpecifiesagloballyuniqueIPaddress.Thissamevaluemustbe

configuredintoeveryauthenticatingswitchinthedomain.

chap|pap SetsthePWAprotocolto:

•CHAP(PPPChallengeHandshakeProtocol)‐encryptstheusername

andpasswordbetweentheend‐stationandtheswitchport.

•PAP(PasswordAuthenticationProtocol‐doesnotprovideany

encryptionbetweentheend‐stationandtheswitchport.Thisisthe

default.